SDC-102 Screwdriver Controller with Memory Instruction Manual
2006 Ameritron 1
Introduction
The SDC-102 Screwdriver Controller provides manual operation for tuning
screwdriver antennas. In addition, tuned positions can be saved in one of the 10
presets so it can be recalled later. A 4-digit counter is used to display the current
antenna position. A sensor is required for the counter and automatic operation
to function properly. This controller is compatible with single and dual sensor
setups. If your antenna does not have a sensor installed, contact the antenna
manufacturer or Ameritron.
Features
• 4-Digit Turns Display
• 10 Programmable Presets
• Manual Up/Down Buttons
• Current Sensor Trip for Antenna/Motor Protection
• Auto-Park: Lowers antenna to lowest position and zeros counter
• Powered From 12V Vehicle Supply
Front Panel
• Power: Push button switch powers the controller on and off.
• Up: Moves the screwdriver antenna up.
• Down: Moves the screwdriver antenna down.
• Buttons 1 – 5: Top bank of preset buttons.
• Buttons 6 – 10: Bottom bank of preset buttons.
To Next Page
Loading...