Page 9;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1Item 64014
EF;6GHIJ6KFGLIMNFLMG6MFMO6 E6GPJ
MO!%\M&8?O&8$,4$%FO%!&7$,3*]%S'$$&8
The MO! function allows you to use the Meter for voltage detection.
1. To activate, hold down the
MO! Button in any mode.
2. Move the Meter close to the voltage
source or unshielded conductor. If
voltage is detected, the meter will
beep and the Non-Contact Voltage
Indicator will flash.
3. Release the MO! Button to
stop voltage detection.
QFKMLMR`%6W*8%"2%8&%"89"4,$"&8%"#%
3"W*8=%W&7$,3*%5,V%#$"77%+*%/(*#*8$1
Do not rely solely on NCV detection to
determine the presence of voltage.
F'$&%J&)*(?I22%I/*(,$"&8
If the Meter is not used for approximately 15 minutes, it automatically turns
itself off to conserve battery power. To turn the Meter back on after auto-
off, press any Button or turn the rotary switch. To disable Auto Power-Off,
press and hold down the XITU Button when powering on the Meter.
To Next Page
Loading...