Page 10 ;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1 Item 64014
EF;6GH IJ6KFGLIM NFLMG6MFMO6E6GPJ
N*,#'(*5*8$%I/*(,$"&8
M&$*- Remove plugs from
ends of Test Leads (included)
before connecting to Meter.
M&$*- Test Lead probes have removable
covers for overvoltage protection. With
covers in place, Test Leads are rated for
use with CAT III circuits. Exposed probes
are rated for use with CAT II circuits.
FO0UO%!&7$,3*%N*,#'(*5*8$
Measure AC conductors carrying up to 600 VAC, from 40 Hz to 400 Hz.
Measure DC conductors carrying up to 600 VDC.
QFKMLMR`% Use caution when working
near voltages above 30 VAC rms,
42 VAC peak, or 60 VDC. Voltages this
high present a risk of electric shock.
QFKMLMR` %To prevent damage
to the Meter or personal injury, do
not measure voltages higher than
600 VDC or 600 VAC rms.
1. Plug black test lead into OIN Jack.
Plug red test lead into L8/'$ Jack.
2. Turn Rotary Switch to the
%position.
3. Press ;PMO Button to choose
between AC and DC voltage.
4. While observing polarity, carefully
touch exposed conductors
with tips of probes.
5. Read measured voltage on the Display.
• ″IT” displayed on the Meter
indicates the measurement
exceeds the current range.
6. When testing is complete, turn
Rotary Switch to I;;, remove
Test Leads and store with Meter.
G*5/*(,$'(*%N*,#'(*5*8$
Measure temperature from -4°F to 1382°F (-20°C to 750°C).
1. Connect red end of Thermocouple
(included) to the L8/'$ Jack and
the black end to the OIN Jack.
2. Turn Rotary Switch to the G*5/
position. The Display will show
the current ambient temperature.
Press ;PMO to switch between
Celsius and Fahrenheit.
3. Touch the tip of the Thermocouple
to the object to be tested.
4. Read measured temperature
on the Display.
5. When is complete, turn Rotary
Switch to OFF remove Thermocouple
and store with Meter.
QFKMLMR`%%To prevent electric
shock, remove Thermocouple before
switching between testing modes.
To Next Page
Loading...