123199 04 5
Never place a hot insertion tube in the optional carrying
case.
Use only insulation plugs supplied by AMETEK
Denmark A/S. Do not try to modify the insulation plugs
to make them fit the sensor (CTC-1200 A only).
About the fuses:
The fuse box must not be removed from the power
control switch until the mains cable has been
disconnected.
The two main fuses must have the specified current and
voltage rating and be of the specified type. The
use of makeshift fuses and the short-circuiting of
fuse holders are prohibited and may cause a hazard.
Caution – Hot surface
This symbol is engraved in the grid plate.
Do not touch the grid plate, the well or the insertion
tube when the calibrator is heating up – they may be
very hot and cause burns.
Do not touch the tip of the sensor when it is removed
from the insertion tube/well – it may be very hot and
cause burns.
Do not touch the handle of the calibrator during use – it
may be very hot and cause burns.
Over 50°C/122°F
If the calibrator has been heated up to temperatures
above 50°C/122°F, you must wait until the instrument
reaches a temperature below 50°C/122°F before you
switch it off.
Do not remove the insert from the calibrator before the
insert has cooled down to less than 50°C/122°F.
To Next Page
Loading...
Need help?
General
