Ametek JOFRA CTC-140 A

14 123199 04
3.8 AUTO STEP
The AUTO STEP function (cf. fig. 5) is used to step automatically
between a range of different set-temperatures.

Press . The instrument displays the number of set-
temperature .

Press or to select the required number of steps.

Press to accept your selection. The first set-
temperature will flash.

Press or to select the required temperature.

Press to accept your selection. The next set-
temperature will flash. This process will be repeated until the
last value has been accepted. The extra for which you
wish the calibrator to remain at every step will flash.

Press or to set the required number of minutes.

Press to accept your selection. The function will be
activated.

Press after the last set-temperature to end the function
or to leave the function at any time.