Sequoia / Tahoe Series User Manual California Instruments
M447352-01 REV-A 91
Figure 4-11: Modulation Reference Signal Pinout diagram for Phase B
Figure 4-12: Modulation Reference Signal Pinout diagram for Phase C
4.3 External Analog Control Signal Connector
The Sequoia/Tahoe power supply is provided with an External Analog Control Signal 15-pin connector on
the rear panel. This section contains the setup and operating configuration of the External Analog
Programming of the Output Voltage Waveform, Output Voltage and Current Amplitude, Voltage Monitor,
and Current Monitor. Refer to Figure 4-13 for the connector pin-out diagram and Table 4-2 for connector
pin-out details.
Figure 4-13: External Analog Control Signal Connector
Pin # Name Type Range Function
To Next Page
Loading...
