Sequoia / Tahoe Series User Manual California Instruments
108 M447352-01 REV-A
OUTPUT PROGRAM
Provides setting of phase number, output mode of
operation, individual output parameters, mode of
regulation, current limit, and output waveform selection
MEASUREMENTS
Provides measurement of output parameters and
harmonic distortion, advanced harmonics analysis, no
user settings are available.
TRANSIENTS
Provides setup, running, and saving of output transient
lists.
CONFIGURATION
Provides setup of power-on states, operation profiles,
parameter limits, selection of clock configuration and
mode, and Default screen.
CONTROL INTERFACE
Provides setup of remote analog and digital interfaces,
and Remote Inhibit.
OPERATING MODES (Not
Applicable for TAHOE Series)
Provides a selection of Operating modes such as source
mode, Grid Simulator, and E-Load
SYSTEM SETTINGS
Provides a display of firmware versions, software options
that are installed in the unit; hardware parameter limits,
selection of language and brightness for the display, and
touch-screen calibration.
Table 5-2. HOME Screen Menu Content
5.6 Operating Mode Screen
The top-level menu of the OPERATION MODE screen is shown in Figure 5-10. It can be reached in one
of two ways:
1. Tapping OPERATION mode on the HOME Screen of the front panel touch-screen.
2. Scrolling to OPERATION with the encoder and depressing the encoder switch.
The UP arrow button will return to the previously selected screen menu (in this case the HOME Screen).
The HOME button will return to the HOME screen that has the top-level menu for the sub-menu being
displayed; for the PROTECTION screen top-level menu, is the HOME Screen.
NOTE: This feature applies only to the SEQUOIA series. TAHOE series does not support this mode of
operation.
Figure 5-10. Operation Mode Screen
The following sub-menus are available in the PROTECTION menu:
Entry Description
Source Mode Sets the power supply in source mode
To Next Page
Loading...
