Sequoia / Tahoe Series User Manual California Instruments
M447352-01 REV-A 109
Figure 5-11. Source Mode
SINK-Grid Sim Sets the power supply in grid simulator mode. In Grid Simulator
Mode Sequoia regulates the output voltage to the user-set value
and works as the grid to UUT.
Figure 5-12. Grid Simulator Mode
SINK-eLoad Sets the power supply in eLoad mode. eLoad mode is further
classified into Current Programming mode, Power Programming
mode, and RLC programming mode.
RMS Current Programming: The user can program the RMS current, and phase required as a
load for the UUT.
Figure 5-13. eLoad – Current Programming
To Next Page
Loading...
