Ametek SEQUOIA Series - Page 179

Sequoia / Tahoe Series User Manual California Instruments
156 M447352-01 REV-A
Figure 5-89. Phase Settings
REGENERATIVE CURRENT Programs the Regenerative current value, (Amperes).
Figure 5-90. Regenerative Current Settings
5.7.6 Transients Screen
Refer to Section 5.6.6
5.7.7 Configuration Screen
The CONFIGURATION screen provides a setup of the output mode of operation, power-on states,
operation profiles, parameter limits, and selection of clock mode.
The top-level menu of the CONFIGURATION screen is shown in Figure 5-91. It can be reached in one of
two ways:
1. Tapping CONFIGURATION on the HOME Screen of the front panel touch-screen.
2. Scrolling to CONFIGURATION with the encoder and depressing the encoder switch.
The UP arrow button will return to the previously selected screen menu (in this case the HOME Screen).
The HOME button will return to the HOME screen that has the top-level menu for the sub-menu being
displayed; for the CONFIGURATION screen top-level menu, is the HOME Screen.