Sequoia / Tahoe Series User Manual California Instruments
162 M447352-01 REV-A
Figure 5-98. DC Offset Settings
PROFILES Selects the operational state of the power source; the default is
Profile-0. Up to 15 unique profiles, including transient lists, could
be stored; refer to Figure 5-99. Subsequently, a profile could be
loaded to automatically set the unit to that configuration. To save
the present state, tap on the profile selection button. The profile
could be given an alphanumeric identifier by using the Name
function; refer to Figure 5-100. Tap the SAVE field to store the
present configuration. Tap on the Load field to recall a
configuration and set the power source to that state.
Figure 5-99. CONFIGURATION Menu, PROFILES Sub-Menu
Figure 5-100. PROFILES Menu, NAME Sub-Menu
To Next Page
Loading...
