Sequoia / Tahoe Series User Manual California Instruments
182 M447352-01 REV-A
Figure 5-139. LIST Menu, CURRENT SURGE/SAG Sub-Menu
The CURRENT SURGE/SAG sub-menu has the following fields:
Entry Description
T(ime) Sets the time, in seconds or cycles, that the output current will
dwell at the level set in the A(mpere) field.
A(mpere) Sets the current, in Ampere, that will be reached during the surge
or sag time duration.
To A(mpere) Sets the output current level, in ampere, at the end of the
transient surge/sag event and after a time specified by T(ime).
Rep(ea)t Sets the number of times the surge/sag transient event will be
repeated before execution will proceed to the next event or exit
the transient list. The number of times the transient event is
generated is equal to the value, REPEAT+1. The value should
be zero if only one execution of this event in the list is desired.
Func(tion) Selects the waveform to be used during this section of the
transient sequence. Each section could use a different waveform
from the available library of user-defined waveforms or the three
standard waveforms. The output waveform changes upon entry
into each section and remains in effect for the duration of the
section. The default waveform is always the SINE (sinewave).
Trig(ger) Causes a trigger pulse to be generated for the selected event
when LIST is selected for Trig(ger) Out Source in the SETTINGS
menu.
Delay Sets the time duration, in seconds or cycles, that the voltage
amplitude will stay at the level, To V(olts), before the next
transient event is executed, or the transient list is completed.
Save Completes the transient editing. All data fields should be entered
before saving. The event number is automatically set based on
the selection of either BEFORE or AFTER in the LIST menu and
will be a value between 0 and 99. The event number determines
the order of execution of the transient events in a multiple-event
transient.
Phase Displays the phases that had been selected in the Settings menu.
5.8.6.6 RUN Menu
The RUN menu is used to control transient execution; It provides two selections, CONTINUOUS and
X TIMES, and START/ABORT functions to begin and stop the execution of a list.
To Next Page
Loading...
