Sequoia / Tahoe Series User Manual California Instruments
M447352-01 REV-A 209
When the unit is configured for 3-Phase output, each phase has individual settings. When the unit is
configured for 1-Phase output, only Phase-A is displayed. Tapping on a phase button toggles the selection
of that phase for inputting values. When a phase is selected, its button is displayed with a green color.
When a phase is not selected, its button is displayed with a gray color. When all phases are selected, entry
for one phase will make the same changes for the other phases.
Entry Description
Setting
Resistance User can program the Resistance required as a load for the UUT.
If the user wants to remove the Resistance connection, select NC
on the keyboard. NC refers to “No Connection”. Refer to Figure
5-196.
Figure 5-196. Touch-Screen Numeric Keypad - RLC
Inductance User can program the Inductance required as a load for the UUT.
If the user wants to remove the Inductance connection, select NC
on the keyboard. NC refers to No Connection. Refer to Figure
5-196.
Capacitance User can program the Capacitance required as a load for the
UUT. If the user wants to remove the Capacitance connection,
select NC on the keyboard. NC refers to No Connection. Refer to
Figure 5-196.
NC NC refers to “No Connection”.
APPLY To adjust the settings, the user must input a value for R, L, or C
and then press the apply button for the configured value to be
programmed. Only if there is a change in Resistance, Inductance,
or Capacitance, APPLY button will be enabled, for the user to
configure the settings. Refer to Figure 5-197. If there is no
change, APPLY button will be disabled refer to Figure 5-198.
To Next Page
Loading...
