Sequoia / Tahoe Series User Manual California Instruments
210 M447352-01 REV-A
Figure 5-197. Apply button enabled when there is a
configuration change
Figure 5-198. Apply button Disabled when there is no
change in R, L, or C
RANGE Displays 166 VAC or 333 VAC range for AC-mode, and 220 VDC
or 440 VDC range for DC mode operation. The OUTPUT state
must be OFF for a change in range to be executed.
MODE Displays the source mode of operation.
Synchronize Starts the Synchronization between Sequoia and EUT. Once the
Synchronization is successful it will display “SYNCED”.
Measure
VOLTAGE Displays the true RMS value of the output voltage measured at
the voltage sense lines. In DC-mode only, the voltage is the DC
voltage including polarity.
CURRENT Displays the true RMS value of the output current. In DC mode
only, the current is the DC including polarity.
FREQUENCY When in AC mode, the output frequency is measured at the
sense lines. When in DC mode, this value always reads “DC”.
To Next Page
Loading...
