Sequoia / Tahoe Series User Manual California Instruments
M447352-01 REV-A 267
Figure 8-23: Current Surge/Sag Settings
6. Tap the SAVE field in the CURRENT SURGE/SAG sub-menu.
7. Repeat Steps 4 through 7 two more times using 80 C / 83 ms and 40 C / 150 ms as values.
8. Once the three events are programmed, navigate to the VIEW menu of the TRANSIENTS
screen to view all available events in the transient list. If more events are programmed than
could fit in the window, the arrow buttons on the right side could be used to scroll through the list.
To edit an existing event, move the selection field to the relevant event number and click the
encoder switch to select it. Use the edit fields to edit or delete the event, or to add events before
or after the selected one.
9. Navigate to the RUN menu of the TRANSIENTS screen; refer to Figure 8-24.
Figure 8-24: RUN Menu
To Next Page
Loading...
