Sequoia / Tahoe Series User Manual California Instruments
M447352-01 REV-A 269
Figure 8-26: RUN Menu: Start and Abort Fields
8.2.4 Saving Transient List Programs
When the power source is turned off, the transient list that was programmed is not automatically saved.
Therefore, the programmed transient list would be lost if the unit is turned off. However, transient programs
could be saved in nonvolatile memory for later recall. This allows multiple transient list programs to be
recalled quickly without the need to enter all parameters each time. Transient lists are stored as part of the
overall power source operational configuration state in any of the available profile state registers; refer to
the CONFIGURATION screen in Section 5. To save a transient list, proceed as follows:
1. After setting up a transient list, run it so that it is transferred to the main memory.
2. Tap on the PROFILES field in the CONFIGURATION menu; refer to Figure 8-27.
3. Tap on one of the fifteen PROFILEx buttons (x = 0 to 14) to select it.
4. Tap on the NAME field to open the NAME sub-menu to assign a unique name to the profile.
Otherwise, tap on the SAVE field to save the configuration state of the power source to a profile
memory register.
5. The profile could be recalled at a later time by selecting the appropriate selection button and
tapping on the LOAD field.
Figure 8-27: CONFIGURATION Menu, PROFILES
Selection
To Next Page
Loading...
