Ametek SEQUOIA Series - Page 36

Sequoia / Tahoe Series User Manual California Instruments
M447352-01 REV-A 13
2.7 Output Power and current ratings – Single Phase
The following output characteristics are common for Source mode, SINK-Grid simulator mode, and SINK-
Electronic Load mode (SEQUOIA and TAHOE models)
Model Output Power
(KVA)
AC/DC and
AC+DC mode
AC mode Output Current,
AC+DC mode Output
Current,
Rated (Per Phase)
DC mode, Rated (Per Phase)
RMS (A)
Low - 166 V
RMS (A)
High - 333V
RMS (A)
Low - 220 V
RMS (A)
High - 440V
RMS (A)
SQ0022 /
TA0022
22.5 135 67.5 102.3 51.1
SQ0030 /
TA0030
30 180.1 90.1 136.5 68.2
SQ0045 /
TA0045
45 270.3 135 204.6 102.3
SQ0090 /
TA0090
With one chassis
90 540.6 270.3 409.1 204.5
2.8 Output Current Limit Characteristics - Continuous
Output current limit characteristics are applicable for Source and Sink operating Modes, Refer to Figure
2-3.
Figure 2-3: Output current limit characteristics- Continuous
SQ0450/
TA0450
5 x SQ0090
5 x TA0090
450 901 450.5 681.8 340.9
SQ0540/
TA0540
6 x SQ0090
6 x TA0090
540 1081.2 540.6 818.2 409.1