UPS + Isolation Transformer User Manual
© 2020 AMETEK Electronic Systems Protection | Technical Support: 1-800-645-9721 | surgex.com 4
STATEMENT OF INTENDED USE
NOTE:
• The UPS is intended for stationary use.
• The UPS is not intended for patient contact or for installation that will cause accidental
contact of patients.
• Do not use this UPS for life support applications in which a malfunction
or failure of the UPS
system
could
cause
failure or significantly
alter
the performance of a life-support device.
• Do not use this UPS near or
around
flammable
gases.
Do not use this
UPS within oxygen-enriched atmospheres.
• Do not disassemble the UPS.
• The UPS is CLASS 1 equipment.
• Do not attempt to power the UPS from any receptacle except a properly grounded
receptacle that matches the input plug provided with the UPS.
• Do not place the UPS near water or in environments of excessive humidity.
• Do not allow liquid or any foreign object to get inside the UPS.
• Do not block air vents on the front of the UPS.
• Do not plug appliances such as hair dryers, fans, heaters, etc. into the
UPS.
• Do not place the UPS under direct sunshine or close to heat emitting sources
(excessively warm temperatures will shorten battery life).
• This UPS is intended for installation in a temperature controlled, indoor area free of
conductive contaminants.
• The AC power source for the UPS should be conveniently near the UPS and easily
accessible – avoid extension cords or temporary power strips to power the UPS.
To Next Page
Loading...
Need help?
General
