shots from rapid firing. Setting 0.10 is a good starting point, however at the indoor range you
may need to start at 0.13 and work up from there.
6 – BEEP VOLUME, this setting simply controls how loud the beep is. Loudest beep is
suitable for live fire when the beep needs to be heard through hearing protection. The lowest
volume is suitable for dry fire training at home.
Bluetooth connectivity
Commander has Bluetooth connectivity which allows shot times to be downloaded or
streamed into a smart phone or tablet for scoring or analysis. Commander utilizes a simple
and open protocol, which means any developer will be given access upon request.
The Commander team is very proud to be first timer in the world integrated into the leading
match scoring app: PractiScore on both platforms, Android and iOS. Check their website at
https://blog.practiscore.com/android-app-bluetooth-timers/ for details.
Additional settings:
Serial number and MAC address:
When timer is off, hold button on the front panel as you turn it on to display your timer's
serial number, MAC address for Bluetooth module, and last 4 digits of MAC address for quick
reference (Commander’s Bluetooth name is “AMG Lab COMM XXXX, with XXXX being last 4
digits of the MAC address), pressing any button will exit from this screen and continue into
normal timer operation.
Reset to factory defaults:
With Commander turned off press and hold the “M” and buttons then power on. This will
reset everything to factory defaults. Commander will automatically reboot during this
procedure.
Advanced setting menu:
To enter advanced “set and forget” settings that are not normally changed often, turn timer on
while holding “M” button.
Self-beep setting allows Commander to avoid detecting its own beep at high
sensitivities, when it is set to “NO” shots during beep sound at any sensitivity level are
ignored. Setting this to “YES” means Commander will ignore any shots during the beep
at sensitivities #7 and up, it will still record shots during beeps at sensitivities below #7.
Shdn. Del. Is the auto shut down timeout..
Str length, is how long Commander will listen for shots after it started, you can choose
from two options here, 5 minutes or 10 minutes.
BLE push, is a bluetooh setting to enable or disable pushing shot data through the
bluetooth protocol with every detected shot, normally this is off and shot string data can
be pulled from timer on demand via bluetooth app on smartphone.
Battery voltage, battery unit's voltage level, this is not a setting but just reference data,
providing additional insights into battery stage, when battery is getting close to
depletion, this voltage will be close to 4.00V.
To exit this menu into normal timer mode simply keep pressing “M” button to cycle through all
settings and exit out of this menu.
To Next Page
Loading...