What to do if water does not flow through amiad Filtomat M100?
If water isn't flowing through your amiad Water Filtration System, first check the inlet lines for any blockages. Additionally, ensure that all isolating valves are open to allow water flow.
How to fix amiad Filtomat M100 when the filter does not flush?
If your amiad Water Filtration System isn't flushing, make sure that all valves are open. Also, the pressure differential might not be correct. To address this, perform a manual flush by closing the filter outlet valve, ensuring the filter outlet and inlet pressures are equal, performing a manual flush as described in item 7, page 9, and checking the pressures at the inlet valve and in the rotor chamber.
What to do if there is excessive pressure in the rotor chamber of amiad Water Filtration Systems?
If you observe excessive pressure in the rotor chamber of your amiad Water Filtration System, inspect the drain pipes to ensure they are clear. If necessary, replace the existing flush drain line with a larger diameter line or shorten the existing lines.
What to do if pressure differential exceeds 0.7 bar during normal operation of amiad Water Filtration Systems?
If the pressure differential exceeds 0.7 bar (10 psi) during normal operation of your amiad Water Filtration Systems, check the coarse filter.
Key operational parameters including flow rate, pressure, filtration area, and dimensions for the filter models.
Essential safety precautions for operating, installing, and maintaining Amiad filtration systems.
Steps for checking the filter, cleaning, and winterization to ensure proper upkeep and longevity.
Detailed technical drawings and dimensions for the Amiad Filtomat M104LPN and M106LP electronic filters.
A detailed explanation of the automatic self-cleaning process and its operational mechanics.
Comprehensive guidance on filter installation, including design recommendations, preparations, and procedures.
A guide to the initial startup and operation of the filter after installation, including checks.
Solutions for common problems encountered during filter operation, covering flushing, pressure, and flow.
Step-by-step instructions for draining, removing, and re-installing filter components for maintenance.
Comprehensive lists of part numbers, descriptions, quantities, and materials for filter models and components.
Visual diagrams illustrating the filter components, cover, and dirt collector for identification and assembly.
Diagram illustrating the layout and connections of control tubes for the M100 Electronic series.
Details of the warranty terms, conditions, coverage, and exclusions for Amiad products.
General| Category | Water Filtration Systems |
|---|---|
| Screen Material | Stainless Steel |
| Model | Amiad Filtomat M100 Series |
| Filtration Type | Screen Filtration |
| Operating Pressure | Up to 10 bar |
| Filtration Degree | 50-3000 micron |
| Cleaning Mechanism | Automatic Self-Cleaning |
| Power Supply | 220V AC |
| Backwash Duration | 10 to 20 seconds |
| Inlet/Outlet Size | 2" - 8" |
To Next Page
