amiad SAF-6000 - User Manual

Questions and Answers

B
Brandi OsbornAug 4, 2025
What to do if amiad Water Filtration Systems filter is clogged?
- D
  Deanna EsparzaAug 4, 2025
  If the amiad Water Filtration Systems filter is clogged due to heavy dirt load or too high water flow rate, close the filter’s downstream valve. Press the reset button to reset the fault mode, turning off the fault indication lamp. Perform a few consecutive manual flush cycles and monitor the PD signal. Once the filter is clean, gradually open the downstream valve and monitor the PD and the flow-rate, ensuring that the filter doesn’t exceed its designated flow-rate. If the PD switch is faulty, have a qualified electrician check the PD connections and operation, and replace the switch if necessary.
J
Jennifer WilliamsAug 13, 2025
What to do if amiad Water Filtration Systems motor protector was activated?
- D
  Deborah StevensonAug 14, 2025
  If the motor protector of amiad Water Filtration Systems was activated and the fault indication lamp is blinking in red, you should: 1. Check the motor power consumption when not loaded. 2. Check the limit switches for correct operation and verify that each one of them stop the motor at its designated point. 3. Verify 3 phase 380VAC power supply to the control board and the motor. 4. Disconnect the drive unit from the suction scanner shaft and verify free turning of the suction scanner.
C
Colton WeberAug 25, 2025
What to do if amiad Water Filtration Systems limit switches are malfunctioning?
- K
  Kimberly StevensonAug 25, 2025
  If the limit switches of amiad Water Filtration Systems are malfunctioning and the fault indication lamp is blinking in red, check that the limit switches are not mechanically stuck. Also, have a qualified electrician check the wiring and the functionality of the limit switches.

Summary

Technical Specifications

General Specifications

Provides key operational parameters like flow rate, pressure, dimensions, temperature, and weight.

Flushing Data

General Safety Instructions

Core Safety Principles

Covers essential safety practices for operating and maintaining the filter system.

Installation Safety Guidelines

Addresses safety considerations during the filter installation process.

Electrical Safety Precautions

Crucial safety measures related to the filter's electrical wiring and power supply.

System Operations Safety

Pneumatic and Hydraulic Safety

Civil Engineering Safety Measures

Commissioning Safety Protocols

Operation and Control Safety

Safety rules for operating the filter and adhering to its control system.

Maintenance Procedures

Pre-Maintenance Steps

Steps to take before performing any maintenance or non-regular operation on the filter.

Mechanical Maintenance Tasks

Troubleshooting Guide

Fault Diagnosis and Corrective Actions

Identifies common symptoms and their potential causes and corrective actions.

Motor Protection Faults

Limit Switch Malfunctions

amiad SAF-6000 Specifications

General

Model	SAF-6000
Category	Water Filtration Systems
Filtration Type	Automatic Self-Cleaning Screen Filter
Self-Cleaning	Yes
Screen Material	Stainless Steel
Control System	Electronic Controller
Filtration Degree	50-3000 micron
Operating Pressure	2-10 bar
Cleaning Mechanism	Suction Scanners