amiad EBS-10000 - User Manual

Questions and Answers

P
Paula SmithAug 5, 2025
Why is the fault indication lamp lighted in red on my amiad EBS-10000 Water Filtration Systems?
- B
  Brandon SpencerAug 5, 2025
  If your amiad Water Filtration Systems filter is experiencing a continuous signal from the pressure differential switch for more than 15 minutes, indicated by a red fault light, it could be due to a clogged filter from heavy dirt or high water flow. Try closing the downstream valve, then press the reset button. Perform a few manual flush cycles, watching the PD signal. Once clean, gradually reopen the downstream valve, checking the PD and flow rate to ensure it stays within the filter's limits. Another cause could be a faulty PD switch, in which case you should ask a qualified electrician to check the connections and operation, and replace the switch if needed.
M
marypetersAug 14, 2025
What to do if the motor protector was activated on amiad EBS-10000 Water Filtration Systems?
- E
  Evan GonzalezAug 14, 2025
  If the motor protector is activated and the fault indication lamp is blinking red on your amiad Water Filtration Systems, it could be due to the motor operating under too high a load. Have a qualified electrician perform the following checks: 1. Check the motor's power consumption when it's not loaded. 2. Check the limit switches to ensure they are working correctly and stopping the motor at the right points. 3. Verify that the 3-phase 380VAC power supply to the control board and motor is correct. 4. Disconnect the drive unit from the suction scanner shaft to verify the suction scanner can turn freely.
J
Jillian WatsonAug 26, 2025
How to fix malfunctioning limit switches on amiad EBS-10000?
- J
  Jennifer MacdonaldAug 26, 2025
  If the fault indication lamp is blinking red on your amiad Water Filtration Systems due to malfunctioning limit switches, it may be because a faulty limit switch isn't stopping the motor at the correct point, which could activate the motor protection. First, check that the limit switches aren't mechanically stuck. Then, have a qualified electrician check the wiring and functionality of the limit switches.