Amica EB 944 100 E - Operation

12
OPERATION
The electronic prgrammer Tb is
equippedwithelectronicsensorswhich
are switched on by touching or press-
ing the sensor surface for at least one
second.
Each sensor reaction is conrmed by
the beep.Keep the sensor surface clean
at all times.
Important!
Inovensequippedwith the electronic
programmer Tb, the time “0.00” will
startashinginthedisplayeldupon
connection to the power supply.
The programmer should be set with
the current time. (See Electronic
programmer ). If the current time
is not set operation of the oven is
impossible.
Before using the oven for the rst time
The oven is equipped with a retractable
knobs. In order to select a function do the
following:
1. Gently press and release a knob which
will pop out,
2. Turn the oven functions selection knob to
the desired function.
Symbols printed around the knob indicate
available oven functions.
1
2
 Remove packaging, clean the interior of
the oven and the hob.
 Takeoutandwashtheoventtingswith
warmwaterand alittlewashing–upliq-
uid.
 Switch on the ventillation in the room or
open a window.
 Heattheoven(toatemperatureof250°C,
for approx. 30 min.), remove any stains
and wash carefully; the heating zones
of the hob should be heated for around
4 min. without a pan.