36
OPERATION IN CASE OF EMERGENCY
In the event of any fault:
• Turn o the appliance,
• Disconnect the power supply
• By following the instructions given in the table below, the user can correct some minor
issues. Please check the consecutive points in the table before you refer the repair to
customer service.
Problem Reason Remedy
1. The appliance does not
work
no power check the fuse, replace if
blown
2. Oven lighting does not
work
loose or damaged bulb Replace the blown bulb
(see Cleaning and main-
tenance)
3. Display shows blinking
time "0.00"
The appliance was un-
plugged or there was a
power outage.
Set the current time (see
section "Programmer
operation")
4. Fan does not work Risk of overheating! Immediately unplug the appliance or
switch o the main circuit breaker. Refer the repair to the
nearest service centre.
5. E1 Error on the display Meat probe failure you can use the oven
without the meat probe
6. E0 Error on the display oven chamber sensor error disconnect the appliance
from wall socket (fuse)
and contact the nearest
service centre
If the problem is not solved, disconnect the power supply and report the fault to the nearest
service centre. Note! All repairs must be performed by qualied service technicians.
To Next Page
Loading...
