Why won't my Amica Dishwasher start?
If your Amica Dishwasher program won't start, make sure the plug is properly inserted into the wall outlet and check the fuses in the electrical system. Also, ensure that the water supply valve is open and that the dishwasher door is closed. Verify that the dishwasher is turned off and on again using the On/Off button. Finally, make sure that the water supply filter and dishwasher filters are clean.
What to do if food residue remains on the Amica EGSP 14697 E dishes?
If you find food residue on your dishes after a wash, several factors could be at play. The dishes may be improperly loaded, preventing water from reaching all surfaces, or the basket might be overloaded. Ensure dishes don't touch each other. Other causes include using too little detergent, selecting a gentle wash program, a spray arm clogged with food, clogged or improperly fitted filters, or a clogged drain pump.
What to do if there is water in the Amica EGSP 14697 E when the program completes?
If water remains in your Amica Dishwasher after the program finishes, the water drain hose might be clogged or kinked. Another possibility is that the filters are clogged. Finally, ensure the program has fully completed.
What to do if one of the program indicator lights up and the Start/Pause indicator flashes on my Amica EGSP 14697 E Dishwasher?
If one of the program indicators lights up and the Start/Pause indicator flashes on your Amica Dishwasher, close the door.
Why are there white spots or streaks on my Amica EGSP 14697 E Dishwasher dishes?
If white spots or streaks appear on your dishes, it could be due to several reasons. You may have added a very small amount of detergent or a low dose of rinse aid. Also, check if you are using special salt, especially if you have hard water. Ensure the water softening system isn't set too low and that the special salt dispenser lid is properly closed.
Why aren't my Amica EGSP 14697 E Dishwasher dishes drying?
If your dishes aren't drying in the Amica Dishwasher, it could be because you've selected a program without a drying phase. Also, the special salt dosage might be set too low, or the dishes are being removed too soon from the dishwasher.
Why does my Amica EGSP 14697 E Dishwasher stop during a washing program?
Your Amica Dishwasher might stop mid-cycle due to a power failure or no water supply. Also, the program may have been paused.
Why do I hear clinking noises inside my Amica EGSP 14697 E Dishwasher?
Clinking noises in your Amica Dishwasher usually mean the dishes are arranged incorrectly or the spray arm is hitting the dishes.
Why do traces of corrosion appear on my Amica EGSP 14697 E cookware?
Corrosion on cookware in your Amica Dishwasher may be due to low-quality stainless steel. It may also be caused by a lot of salt in the rinse water, a special salt dispenser lid that is not closed properly, too much special salt spilled when filling the dispenser, or the appliance being improperly grounded.
General| Type | Freestanding |
|---|---|
| Appliance placement | Freestanding |
| Energy Efficiency Class | E |
| Drying class | A |
| Delayed start timer | Yes |
| Delayed start | 1-24 h |
| AquaStop function | Yes |
| Annual Energy Consumption | 266 kWh |
| Delay Start | Yes |
| Half Load Option | Yes |
| Number of Place Settings | 14 |
| Water Consumption per cycle | 9.5 L |
| Width | 60 cm |
| Annual Water Consumption | 2660 L |
| Depth | 600 mm |
To Next Page