29
CLEANING AND MAINTENANCE
By ensuring proper cleaning and mainte-
nance of your cooker you can have a sig-
nicant inuence on the continuing fault-free
operation of your appliance.
Before you start cleaning, the cooker must
be switched o and you should ensure
that all knobs are set to the “”/“0” posi-
tion. Do not start cleaning until the cooker
has completely cooled.
Burners, the burner hob grate,
the cooker housing
In the case of soiled burners and grate,
these elements must be removed from
the cooker and washed with warm water
and washing – up products intended for
fats and soils. Next, wipe them dry. After
the grate has been removed, wash the
burner hob carefully and wipe with a dry
and soft cloth. In particular, ensure ame
openings in rings under caps are clean,
see the gure below. Do not use steel wire
or drill holes.
Wash enamel elements of the cooker with
light washing products. When cleaning
do not use cleaning agents with a strong
abbrasive eect, such as scouring pow-
ders containing an abrasive, abrasive
compounds, abrasive stones, pumice
stones, wire brushes and so on.
Before you start using the cooker with
stainless steel hob, its cooking zone rst
needs to be carefully washed. It is impor-
tant to remove glue residues from the foils
taken o trays during installation, as well
as adhesive tape applied during packag-
ing. The hob should be cleaned regularly
after each use. Do not allow the hob to get
heavily stained, particularly from burnt-on
spillages from boiled over liquids.
Caution!
Burner elements must always be
clean. Water particles may hamper
gas ow and produce an incorrect
burner ame.
To Next Page
Loading...
