Why won't my Amica PG6511WSPR burner ignite?
If the Amica Cooktop burner won't ignite, it could be due to contaminated flame slots. To resolve this, close the gas cut off valve, close burner control knobs, ventilate the kitchen, take the burner out of the cooktop, and then blow and clean the flame slots.
What to do if my Amica PG6511WSPR igniter does not work?
If the igniter on your Amica Cooktop isn't working, here are a few things to check: * First, verify that there isn't a power cut by checking the home power fuse and replacing it if necessary. * Next, make sure the gas supply is on by opening the gas cut off valve. * Also, the igniter may be contaminated, try cleaning the igniter. * Finally, ensure you are holding the control knob depressed until the flame goes on and persists, as releasing it too soon can cause the igniter to fail.
Why does the burner on my Amica PG6511WSPR Cooktop extinguish immediately after lighting?
If the burner on your Amica Cooktop extinguishes immediately after lighting, it's likely because the control knob was released too soon. Make sure to hold the control knob depressed until the flame goes on and persists.
To Next Page
General
