23
OPERATION
EN
Using cooktops with control knob ignition (Zp)
l Press the selected control knob and turn anti‑clockwise into Burner ON large ame position.
l Hold depressed until gas is on re
l Release the knob and set the required ame size.
Using cooktops with leak protection (Zt)
protection
spark igniter
Hold the burner’s control knob depressed for approx. 10 seconds in Burner ON large ame position. This way, you
activate the protection device.
Repeat the attempt if the protection has not activated for the rst time.
Leak protection will cut o the gas supply if there is no ame for approx. 60 seconds.
At the Zt cooktops, the gas supply to the burners is adjusted with the knobs equipped with the leak
prtection.
What to do if surplus gas leak
occurs
1 – gas network
2 – gas cut o valve
A – valve ON
B – valve OFF
10
In any emergency, proceed as follows:
l turn the burners o
l set the cut o valve OFF (see g. 9 B)
l ventilate the kitchen
l report the unit for repair at a service department of a licensed and authorised repair shop
l refrain from using the appliance until it is returned to its operating condition
NOTE
The user can x some minor malfunctions himself, by following the instructions given in this manual.
The burner does not ignite, and gas is smelled;
l Close burner control knobs
l Close the gas mains / supply cut o valve
l Ventilate the kitchen
l Take the burner out of the cooktop
l Clean and blow the slots
l Insert the burner back in place
l Resume ignition attempt.
If the burner still fails to go on, report for a licensed repair.
To Next Page
