What to do if my Amica WA 14690-1 W Washer shows error E10?
If the Amica Washer displays error code E10, it indicates low pressure or no water entering the drum. To resolve this, first, ensure the water valve is fully open. Next, inspect the water inlet hose and filter for any blockages. Finally, verify that the water pressure meets the required level for the washer to operate correctly.
What to do if my Amica WA 14690-1 W Washer displays error E21?
If your Amica Washer is not draining water properly and displays error code E21, the issue likely lies with the water drain pump or filter. You should inspect and clear any obstructions from the water drain pump and filter to ensure proper drainage.
General| Type | Front-loading |
|---|---|
| Appliance placement | Freestanding |
| Product colour | White |
| Built-in display | Yes |
| Control type | Electronic |
| Door hinge | Left |
| Drum material | Stainless steel |
| Maximum spin speed | 1400 rpm |
| Spin-drying class | B |
| Washing class | A |
| Number of washing programs | 16 |
| Delayed start timer | Yes |
| Energy efficiency class | A+++ |
| Energy efficiency class detail | A+++ |
| Energy consumption washing per cycle | 0.49 kWh |
| Water consumption washing per cycle | 49 L |
| Width | 60 cm |
| Depth | 55 cm |
| Height | 85 cm |
| Noise level (washing) | 58 dB |
| Noise level (spinning) | 78 dB |
| Water consumption | 49 L |
| Dimensions (H x W x D) | 85 x 60 x 55 cm |
To Next Page
