7
In-wall installation
Preparing the ALF120
A pack of felt pads are supplied with
the ALF120. These must be fitted to the
ALF120 when wall-mounted to reduce
bass sound coupling into the walls and
floor.
Fix six felt pads to the underside of•
the cabinet.
Fix fifteen felt pads to each of the•
front and back surfaces
Fit six felt pads to each of the side•
surfaces of the cabinet
The drawing below shows the correct
locations for the pads.
Connecting the ALF120
Once the pads are fitted the ALF120 is
ready to be connected.
• Position the ALF120 close to the wall.
• Cables will be marked with a coloured
line or have a moulded rib on one
edge.
By convention this wire is the +
(positive) wire. The unmarked wire is
the - (negative) wire.
coloured line
rib
Connect the cable(s) to the terminal•
panel, observing polarity.
To Next Page
Loading...