Amina ALF120 - Wall Finishing

9
In-wall installation
Making good the wall
Preparing the wall panel
The wall may be a new build or you could
have opened a cavity in an existing wall
to install the ALF120. In either case it is
now necessary to build/re-build the wall
to complete the installation.
Cut the section of wall board that will•
cover the ALF120.
Offer up the cut wall panel in the•
position where it will cover the
ALF120.
Mark up the position of the centre line•
of the ALF120.
Panel
covering
the
ALF120
Centre-line
of the
ALF120
Fitting the gasket
Lift off the wall panel and place the•
gasket in the position shown at the
base of the ALF120.