EasyManuals Logo

Amino Remote Control User Manual

Amino Remote Control
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4.1 TV Brand Codes
In order for the remote to transmit the correct signals to control the TV, the remote must be
programmed with a 3-digit code corresponding to the type of TV in use.
This is done in the following way:
Identify the make of the TV that is in use. E.g. Sony, Magnavox etc.
Find the TV make listed in the branding table in Appendix A.
Simultaneously press and hold the TV and OK buttons on the remote.
After approximately 2 seconds, the TV button will light.
Release the TV and OK buttons – the TV button remains illuminated.
Now enter the 3-digit brand code according to the make of the TV that is being controlled.
As each of the digits are entered, the TV button will briefly flash off and on again
When the third digit has been entered, the TV button will go out.
If a TV brand code has been entered that the remote does not recognize, the TV button will
flash rapidly for a second and remain illuminated. If this happens, re-enter the correct TV brand
code.
Verify that the remote control works with the TV.
Most TV makes have more than one brand code listed in the brand code table – if this is the
case try all brand codes that are listed for that make until a suitable match is found.
If no brand code is listed for the TV, try brand codes for Philips and NEC TVs.
Page 4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Amino Remote Control and is the answer not in the manual?

Amino Remote Control Specifications

General IconGeneral
BrandAmino
ModelRemote Control
CategoryRemote Control
LanguageEnglish

Related product manuals