AML Base X2 - Default Example Outputs

User Manual for AML Oceanographic BaseX2
17
The default data channel outputs with all calculated parameters turned on are:
SV,P sensors
Date
Time
Sound velocity
Pressure
Battery
Density
Salinity
mm/dd/yy
hh:mm:ss.ss
m/s
dbar
volts
kg/m
3
ppt
SV, Turbidity sensors
Date
Time
Sound velocity
Turbidity
Battery
mm/dd/yy
hh:mm:ss.ss
m/s
NTU
volts
CT, C, T sensors
Date
Time
Conductivity
Temperature
Battery
Density
Salinity
Sound velocity
mm/dd/yy
hh:mm:ss.ss
mS/cm
C
volts
kg/m
3
ppt
m/s
Note: These are examples of the default configurations. Your data channel outputs will be entirely
dependent on which Xchange
TM
sensors are installed.
Default Example Outputs:
Keyboard inputs in the output capture shown below are in bold type.
>Base.X V2 Version 4.22 SN:0002
AML Oceanographic Ltd.
942.8 MBytes installed
>scan
06/25/13 15:56:40.99 0000.000 0000.22 007.63
>monitor
06/25/13 15:56:47.03 0000.000 0000.14 007.63
06/25/13 15:56:47.53 0000.000 0000.13 007.63
06/25/13 15:56:48.03 0000.000 0000.16 007.63
06/25/13 15:56:48.53 0000.000 0000.22 007.63
06/25/13 15:56:49.03 0000.000 0000.24 007.63
06/25/13 15:56:49.53 0000.000 0000.26 007.63
>dis options
[Instrument]
Type=Base.X V2
EmulationMode=disabled
UseCustomHeader=yes
SN=2
Firmware=V4.22
SampleUnits=/ second
SampleInterval=2
PressureInc=0.00
SoundInc=0.00
LogFile=data.txt
Date=2016-01-27
Time=15:56:58
MemorySize=942.8 MB
MemoryUsed=3.8 MB
DisplayTime=yes
DisplayDate=yes
DisplaySalinity=no
DisplayDensity=no
DisplaySoundVelocity=no
DisplayBattery=yes
RelayMode=RS232 mode
RealtimeLogging=yes
LoggingTimeout=0
StartupDelay=10
DisplayHeader=yes
StartupMode=prompt
CharacterReception=yes