Ammann APR 2220 - Electrical Start and Operation for APR 3020;3520

3.6.4 Elec tri cal start (APR 3020 / 3520)
1)
•
Set the en gine speed le ver (1) to full load (MAX).
•
In sert the ig ni tion key (1) and turn to «I»; charg ing in di ca tor
lamp (4) and oil pres sure lamp (5) must light.
•
Turn ig ni tion key «II»; as soon as the en gine starts, re lease
the ig ni tion key.
1)
Spe cial equip ment
3.6.5 If the en gine starts
•
In di ca tor lamp (3) lights to show that the en gine is op er at ing.
•
Set the en gine speed le ver (1) to idle (MIN).
•
Al low the en gine to run for 1-2 min utes in or der to warm up.
Attention
The ig ni tion key must spring back to Pos. «II» au -
to mat i cally and must re main in this po si tion dur -
ing op er a tion.
The charg ing and oil pres sure in di ca tor lamps
must ex tin guish di rectly af ter each start.
Be fore each new start, turn the ig ni tion key back to
«0».
0
I
II
2
3
4
5
B3299076.cdr
B3299089
1
MAX
B3299088
MIN
1
1 – 2 min.
3. Ope ra ti on
47