4.1 Load ing and trans por ta tion
Af ter load ing the ma chine should be lashed in place.
Use the cen tre-of-grav ity sus pen sion point (1) in or der to lift the
ma chine.
4. Trans port
50
Danger
Only use suf fi ciently strong and se cure load ing
ramps when load ing.
Check the con tact points (frame, lift ing rings) be -
fore use for dam age and wear. Im me di ately re -
place dam aged parts.
Se cure the ma chine against roll ing or slip ping off
and against tip ping over.
En sure that no per sons will be en dan gered.
When load ing, lash ing down and lift ing the ma -
chine al ways use the pro vided lift ing points.
Per sons are in dan ger, if they
• go near swing ing loads or
• stand un der swing ing loads
Lock the tow-bar to load ing and trans port.
To Next Page
Loading...
