26 ASC 70 / 90 / 100 / 110 / 130 / 150 / 200 / 250
2. Safety precautions
PRACTICE SAFE MAINTENANCE
Understand service procedures before doing work.
Keep work area clean and dry.
Never lubricate or service the machine while it is moving.
Keep hands, feet and clothing from power-driven parts.
Before performing the machine maintenance:
Park on a at surface.
-
Lower the blade to the ground.
-
Operate the engine at low idle with no load for 3 minu-
-
tes to cool it o.
Move the key into position OFF to cut-o the engine and
-
remove it from the switch.
Move the control safety cut-o lever into position
-
LOCK.
Let the engine to cool-o.
-
Place a “maintenance in progress” sign (seen in the SAFETY DE-
CALS chapter). This sign can be located on the cab door.
In the event maintenance operations require operating the en-
gine, do not leave the machine unattended.
In the event the machine must be lifted, block with appropri-
ate supports the elements of the machine during maintenance/
repair operations.
Inspect certain parts periodically and repair or replace as neces-
sary.
Keep all parts in good condition and properly installed.
Fix any damage immediately. Replace worn or broken parts.
Remove any building of grease, oil, or debris. Disconnect the
ground cable (-) from the batteries before servicing electrical
systems or welding on the machine
CLEAN TRASH FROM MACHINE
Keep engine compartment, radiator, batteries, hydraulic lines,
fuel tank, and operator’s station clean.
Temperature in engine compartment may go up immediately
after engine is stopped.
BE ON GUARD FOR FIRES DURING THIS PERIOD.
Open access door (s) to cool the engine faster, and clean engine
compartment.
MANUALEQUIPOSPESADOS.COM manualequipospesados@gmail.com
To Next Page
Loading...
