5.5 Maintenance work (HONDA-engine)
Only the maintenance work which has to be performed daily
is included in this operating manual. Please refer to the en-
gine operating manual and to the maintenance instructions
and intervals listed therein.
5.5.1 Filling up with fuel
–
Clean the area around the fuel filling socket.
–
Open the cap and
–
check the fuel level visually.
–
If necessary, fill up with fuel; unleaded automotive gasoline
5.5.2 Checking the engine oil level
–
Park the machine horizontally.
–
Clean the area around the fuel filler cap.
–
Open the fuel filler cap.
–
Check the oil level and
–
refill up to the edge of the fuel filler cap if necessary.
–
Check the seal on the dipstick and replace if necessary.
–
Close the fuel filler cap.
–
Allow the engine to run for approximately 1 min. and check oil
level again with engine switched off.
5. Maintenance
Oil
SAE 10W40
API SG-CE
Danger
Fill fuel tank only when engine is switched off
No naked flames.
No smoking.
Fill fuel tank never in enclosed areas.
37
B3299022.cdr
AVP 2220 (H):
MAX (2.5 / 0.66 US gal)
AVP 3020 (H) / 3520 (H):
MAX (6.0 / 1.58 US gal)
l
l
NORMAL
STANDARD
NORMALE
BENZIN
GASOLINE
ESSENCE
Environment
Immediately replace damaged seals.
Collect old oil and dispose of it in an environment
friendly manner.
Do not permit oil to run onto the floor into the
drains.
To Next Page
Loading...
