17
Installing the trailer adapter
1. Remove the nut from the left side of the rear drop-out. Do not
remove the black washer from the rear dropout - keep it on the
axle.
2. Attach the adapter to the axle. Use a 19 mm wrench and make sure
that the adapter is properly secured.
3. Remove the topmost bolt on the adapter with a 13 mm wrench,
leave the two silver washers on top of the adapter.
4. Finally, use the bolt to fasten the trailer hitch onto the adapter.
Our Ampler trailer adapter is compatible with most Thule, Burley and
Croozer trailers. It adapts our M12 thread to an M10.
Alao note the instructions provided by the trailer manufacturer
To Next Page
Loading...
