6 Setup
The bike has made a long journey before reaching you, double-check
the following things:
1. Check the wheels. Spin the wheels and see if they run freely.
2. Check the tyres pressure and make sure the tyres are full before
your first ride. Learn more about the correct tyre pessure on page
10 of this manual.
3. Test the brakes. Spin the front wheel and the rear wheel separately.
Apply the brake levers separately and make sure the brakes are
working correctly.
4. Check the drivetrain. Pedal by hand and check if the chain or the
belt drive runs freely. If your model has gearing, shift through them.
5. Check your bike visually. Does everything seem alright?
Remember to check your bike regularly and read the maintenance
instructions
Final check before your first ride
Take the 4 mm hex key and adjust the perfect seat height
1. Place the bike in a way that allows you to support yourself against
a wall when sitting on it.
2. Put one pedal in its lowest position.
3. Hop on and try to reach the pedal with your heel.
4. You have the perfect seat height when you are able to place your
heel on the pedal with an almost fully stretched leg. Do not lower
the seatpost below the minimum insertion length marked on the
post.
5. Tighten your seat bolts.
And you are good to go!
Adjust the seat height
To Next Page
Loading...
