8
The bike has two standardized assist modes:
• Normal (1) – 25 km/h, 250 W, 100%
(max assist speed, motor power, assist level)
• Boost (2) – 25 km/h, 250 W, 150%
(max assist speed, motor power, assist level)
To switch between the assist modes, hold the power button down for
3 seconds and release it as soon as the buon turns orange.
After releasing the button, it will blink ONCE if it changes to Normal
Mode (assist mode 1) or TWICE if
it changes to Boost Mode (assist mode 2).
You can change and customise the assist modes with the Ampler
Bikes app.
Using the power buon
Changing the assist modes
To turn the lights ON and OFF, hold the power button for 1–2 seconds.
You can also control the lights from your Ampler mobile app.
The bike will remember the last setting, so the lights will be ON when
you leave them on next time you power the bike.
Turning the lights on and off
bike is ON press + hold front + rear lights
switch ON/OFF
release
bike is ON press + hold release LED blinks 1x assist mode 1
press + hold release LED blinks 2x assist mode 2bike is ON
To Next Page
Loading...
