Page 4 of 12
Installation Basics
1. Install the “Amplink PDM” App on your smartphone
2. Determine a suitable location to mount the Amplink PDM near the battery
3. Connect the Amplink to the battery, red (+) wire first then the black (ground) wire
4. Open the App, wait for it to pair to the Amplink, then make your settings (See “App Connection
Instructions”)
5. The small green led on the Amplink means the Bluetooth signal is being broadcast. If the light is
not on, it will not connect to your device. It will time out after 1 minute if the unit is not triggered or
currently connected to a Bluetooth device.
5. Connect the trigger wires and output wires using the Posi-connectors or other appropriate method
6. Activate the Amplink PDM using your trigger method
Note: Before completing a full installation of your Amplink, we recommend bench testing to ensure your
setup functions as desired.
Amplink PDM App
The app is designed to be simple and straight to the point. It is intended to be a tool for programming
and monitoring the output status only. The app has four pages:
Monitor – shows the status of each of the 6 outputs, when paired to the Amplink PDM
Setup – access each output individually to setup the behavior
Triggers – access each of the 3 input triggers to setup the behavior
Information – user manual and product information
1. Load the Amplink PDM app
2. Connect the Amplink PDM power and ground wires to a 12V battery and enable Bluetooth on your
mobile device.
3. See specific instructions on page 5 for initial pairing of Android and Apple devices
Never interact with the app while operating a vehicle.
To Next Page
Loading...
Need help?
General