2830A-XX SERIES THREE DIVER
PORTABLE COMMUNICATOR USER MANUAL
30
5.4.1 DAILY MAINTENANCE
Wipe off any accumulated salt or salt spray on the front panel or connectors using
a clean, damp cloth. Pay particular attention to where the various front panel
components attach to the panel. Inspect the outer case for any damage.
5.4.2 WEEKLY MAINTENANCE
Wipe off any accumulated salt or salt spray on the front panel or connectors using
a clean, damp cloth. Pay particular attention to where the various front panel
components attach to the panel. Inspect the outer case for any damage.
• Inspect the PUSH-TO-TALK BUTTON, binding posts and volume controls for
smooth operation.
• Inspect the case lid O-ring for any damage and replace if necessary.
5.4.3 6 MONTH CHECK
Wipe off any accumulated salt or salt spray on the front panel or connectors using
a clean, damp cloth. Pay particular attention to where the various front panel
components attach to the panel. Inspect the outer case for any damage.
• Inspect the PUSH-TO-TALK BUTTON, binding posts and volume controls for
smooth operation.
• Inspect the case lid O-ring for any damage and replace if necessary.
• Inspect the front panel gasket for any damage and replace if necessary.
• Recharge the battery.
• Perform the 2-Wire and 4-Wire (Full Duplex) system checks as described in
sections 5.1 or 5.2.
5.4.4 YEARLY CHECK
For maximum service life, it is recommended that the diver communicator be sent
back to Amron for a yearly check.
5.4.5 LONG TERM STORAGE
If the diver communicator is to be stored for a period greater than 30 days, it is
recommended that it be stored in a cool dry location. Make sure that the POWER
SWITCH is turned off during storage. The communicator should be stored with
power cord connected to AC Power to ensure that the communicator will be fully
charged and ready to use when needed.
To Next Page
Loading...
