AMT 4562 - Warning; General Safety Instructions.1

WARNING
For Your Own Safety Read Instruction Manual Before Operating Drill Press
1. Wear eye protection.
//
2. Do not wear gloves, necktie, or loose clothing.
3. Clamp workpiece or brace against column to prevent rotation. »
4. Use recommended speed for drill accessory, and workpiece material. -
GENERAL SAFETY INSTRUCTIONS
1. KELP GUARDS IN PLACE and in working order.
2. REMOVE ADJUSTING KEYS AND WRENCHES. From habit of checking to see that keys and
adjusting wrenches are removed from tool before turning it on.
3. KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents.
4. DON’T USE IN DANGEROUS ENVIRONMENT. Don’t use power tools in damp or wet locations, or
expose them to rain. Keep work area well lighted.
5. KEEP CHILDREN AW AY. All visitors should be kept a safe distance from work area.
b. MAKE WORKSHOP KID PROOF with padlocks, master switches, or by removing starter keys.
7. DON’T FORCE TOOL. It will do the job better and safer at the rate for which it was designed.
8. USE RIGHT TOOL. Don't force too! or attachment to do a job for which it was not designed.
9. WEAR PROPER APPAREL. No loose clothing, gloves, neckties, rings, bracelets, or other jewelry to
get caught in moving parts. Nonslip lootwear is recommended. Wear protectective hair covering to
contain long hair.
10. ALWAYS USE SAFETY GLASSES. Also use face or dust mask if cutting operation is dusty. Everyday
eyeglasses only have impact resistant lenses, they are NOT safety glasses.
11. SECURE WORK. Use calmps or a vise to hold work when practical. It’s safer than using your hand
and it frees both hands to operate tools.
12. DON’T OVER REACH. Keep proper footing and balance at all times.
13. MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for best and safest performance..
Follow instructions for lubricating and changing accessories.
14. DISCONNECT TOOLS before servicing; when changing accessories such as blades, bits, cutters, etc.
15. REDUCE THE RISK OF UNINTENTIONAL STARTING. Make sure switch is in off position before
plugging in.
16. USE RECOMMENDED ACCESSORIES. Consult the owner's manual for recommended accessories.
The use of improper accessories may cause risk of injury to persons.
17. NEVER STAND ON TOOL. Serious injury could occur it the tool is unintentionally contacted.
18. CHECK DAMAGED PARTS. Before further use of the tool, a guard or other part that is damaged
should be carefully checked to determine that it will operate properly and perform its intended
function- check for alignment of moving parts, binding of moving parts, breakage of parts, mountin,
and any other conditions that may affect its operation. A guard or other part that is damaged should
be properly repaired or replaced.
19. DIRECTION OF FEED. Feed wuik into a blade or cutter against the direction of rotation of the blade
or cutter only.
20. NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER OFF. Don’t leave tool until it
comes to a complete stop.