Quick Start• 2-2 •
The H.110 Basic Rate ISDN Board
also be a problem with a memory or interrupt conflict. Power
down the chassis and check that the board is properly seated
in the connector and repeat steps 1-4. If this does not
remedy the problem, try removing any other computer
telephony boards in the system. If your chassis is unable to
find the board, consult the number at the end of this section.
6. Run the program “xdsutil” supplied with the driver. Send the
message “IN” to the H.110 Basic Rate ISDN Board. The
board should respond with the message “IA”.
7. Send the message “VC” to the board. Verify that the Receive
Message reads: VCxxxxvvvvHBNA (where xxxxvvvv
is a variable indicating the firmware version).
8. If the Communications screen shows the correct command
responses, your H.110 Basic Rate ISDN Board is
communicating with the host. You may now power down the
computer and attach the necessary cables (see section 3.4)
For technical assistance, call Amtelco at 1-608-838-4194 ext.168.
To Next Page
Loading...