Communicating with the Host• 5-12 •
The H.110 Basic Rate ISDN Board
RD reset DSP (resets DSP chip only)
RIdd deactivate port dd Layer 1 (NT ports only)
RLdd reactivate port dd Layer 1 (NT ports only)
RPdd reset port dd
Setup Commands
SCmsabb(c) Set clock mode m, submode s, arguments a, bb & c
SDxx(#)/(SPID) Set the default directory number and SPID for B
channel xx
SEa Set Encoding mode a, M = Mu-Law, A= A-Law
SFb(xx..xx) Set battery feed enable for each port of bank b
where x values are: F - off, N - on, * - don’t care
SLb(ll...ll) Set protocol layer for each port of bank b (L or H)
where l values are:
2 - Layer 2 support
3 - Layer 3 support
A - AT&T Custom support
D - DMS-100 Switch support
E - CACH EKTS support
N - National ISDN-1 support
SMC Clear the EEPROM configuration contents
SML Load the EEPROM contents onto the board
SMS Save the configuration in EEPROM
SSxy Set Layer 2 system options x & y
STb(xx...xx) Set port types for each port of bank b (L or H)
where x values are:
N - Network Termination
T - Terminal Equipment
U - Undefined/unused
* - No change to port type
TEI Management Commands
TAdd Request TEI assignment for port dd (TE only)
TCdd Request a TEI check for port dd (NT only)
TDddtt Disconnect Link for TEI tt on port dd
TDddP Disconnect Packet Data Link on port dd
TEddtt Establish Link for TEI tt on port dd
To Next Page
Loading...