required number and finally the Enter key to finish. For example, if you want to make Control
Change 7 as value 123.
1) Press MIDI/SELECT button;
2) Press CC No. (will be shown in display)
3) Choose 7 on numeric keypad;
4) Press enter key to specify Control Change as 7;
5) The display shows “---“
6) Press CC DATA. (will be shown in display)
7) Press number key 1, 2, and 3.
8) Press enter key to specify value 123 then press MIDI/SELECT
Button to finish this action.
9) For Velocity, Reverb and Chorus Depth, Pan Pos, Volume you only need to
enter CC Data Value.
Please note for e.g.: after you press enter key the LED display will show --- to
indicate that you pressed enter key and will not disappear until you press
MIDI/SELECT button to finish your choice. After you press cancel key the LED
display will show blank to indicate that you pressed cancel key and will not
disappear until you press MIDI/SELECT button to finish your choice.
To Next Page
Loading...