Upgrading Firmware
26
MXD/T-700 7" Modero X Series® Touch Panels
4. Eject or unmount the flash drive from the PC.
Transfer the Firmware File From the Flash Drive to the Touch Panel
1.
Connect the USB Flash Drive to one of the USB Type A ports on the panel.
2. Go to the Install Firmware setup page (Configuration->Admin->Install Firmware):
a. Press and hold the Sleep button for 3 seconds to open the Settings page.
b. From the Settings page, select the Configuration page. This may require entering a password.
c. From the Configuration page, select Admin.
d. From the Admin Configuration page, select Install Firmware.
3. In the Firmware Installation page, select New to install new firmware from external disk.
4. The popup page displays the name of the firmware file (for example, "SW5968_ModeroX_v2_103_52.kit").
5. Select Ye s, and follow the directions displayed on the popup.
6. Once the panel reboots it will perform the firmware upgrade.
After the upgrade, the unit contains the newly loaded version of firmware.
Upgrading from Previous Firmware
The MXT-700 and MXD-700 allow the option to revert the device to the previous firmware run before an upgrade. To
upgrade the device from previously loaded firmware:
1. From the Settings page, select the Configuration page.
2. From the Configuration page, select Admin.
3. From the Admin Configuration page, select Install Firmware.
4. In the Firmware Installation page, select Previous.
5. The Confirmation Dialog box (FIG. 25) will ask “Are you sure you want to install the following firmware?” The
option to choose Yes will be enabled after five seconds. Press Yes to load the firmware listed, and No to return to the
Firmware Installation popup window.
Make sure this is the only .kit file in this directory - if not, the latest version will be
used.
The Micro USB port cannot be used for firmware upgrades.
FIG. 24 Settings page
To Next Page
Loading...
Need help?
General
