amzchef FC-J18 - Page 8

7
1. Before the first use
1. Remove the appliance from the package.
2. Remove all packaging material such as films, filler, cable holders and cardboard
3 . Should the package contents be incomplete or damages be found, do not take the
appliance into operation. Immediately contact the dealer.
4.Check whether the power supply that you want to use coincides with that of the
appliance. This information can be found on the nameplate.
Note:
1.Dust or production re
sidues can be located on the appliance. We recommend to
clean the appliance as described under “Cleaning”.
2.The motor unit is equipped with a safety switch
3.If the appliance does not start, check if the motor housing, safety cover and knife
are correctly filled.
2. Operation
1.Prepare the dish.
2.Place the non-slip rubber ring on a level surface. Install the glass container on it.
3.Carefully pull off the knife guard.Assemble the knife referring to figure B on page 4.
4.Place the knifes in the container.
5.Add ingredients into the container, align the
cover with the container and position it in
place.
6.Position the motor onto the container, lining up the motor locking tabs to the container
locking slots till the motor unit locks. Connect it to power outlet.
7.Select switchⅠor switchⅡ, gently press and hold the switch.
8.Release the switch when the ingredients have reached desired
consistency.Disconnect the device,wait for the knife stopped spinning. Remove the motor
and safety cover and carefully remove the knifes.
9.Remove the ingredients with the scraper.
Note：①.Continuous working time can't more than 30 seconds at a time.
②.Work for 30 seconds and then rest for 2 minutes.
③.If the ingredients stick on the bowl, please
release the switch,
disconnect the power supply. After using a spatula or chopsticks to
scraping and then process again.