Always lift pans off the ceramic hob – do not slide, or they may scratch the glass.
Using your Ceramic Hob
To start cooking
• After power on, the buzzer beeps once, all the indicators light up for 1 second then go out,
indicating that the ceramic hob has entered the state of standby mode.
1. Touch the ON/OFF control
，
all the indicators show “-” or “- -“,
indicating that the ceramic hob has entered the state of standbymode.
2. Place a suitable pan on the cooking zone that you wish to use.
• Make sure the bottom of the pan and the surface
of the cooking zone are clean and dry.
3. Touching the heating zone selection control, and a indicator next to the
key will flash.
4. Set a power level by touching the “-”, “+”, or slide along the “—” control,
or just touch any point of the “—”.
Or
Or
• If you don’t choose a heat setting within 1 minute, the ceramic hob will automatically
switch off. You will need to start again at step 1.
• You can modify the heat setting at any time during cooking.
• If slide along the “—”, power will vary from stage 2 to stage 8.
To Next Page
Loading...
