This synth has three analogue VCOs.
Each VCO has identical controls, however, VCO3 has an additional switch described
below.
Most controls on this synth are pretty obvious.
TUNE
Use to change the pitch of the VCO.
PW
Changes the pulse width of the square wave.
WAVE
Use to select one of the three waveforms.
Level
Sets the audio level (amplitude) of the VCO.
MIDI Pitch and VCO3 MIDI PITCH switch
Note: Pitch from the MIDI to CV converter is hard wired to all the VCOs. VCO3 has a
bypass switch. When this is on, VCO3 will not be affected by MIDI pitch. It becomes a
free running oscillator. In this state, it can be used as a modulator, for example, as a
LFO.
To Next Page
Loading...