ANALOX Sub Aspida - Page 15

ADM, HBOT & Sub Aspida
User Manual Int. Approved
Document ref: PSA-811-14 June 2017 Page 13 of 43
Copyright © 2017 Analox Ltd. All Rights Reserved.
Commercial in Confidence
The following lists the conditions that may be observed during a charge.
Battery icon state
Audible warning
Charge status
>> (animated)
None
Charging (charge setup)
>> >> (animated)
None
Charging
>> (animated)
None
Charging
(approx. 1.5 hours remain)
Success beep
Charge complete
(flashing)
Fault beep
Charge fault
Batteries not rechargeable
Fault beep
No batteries
The normal charge period for a set of fully discharged batteries is approximately 4.5 hours.
WARNING: During charging, the device will warm up. This effect is normal. It is however
suggested that the device is charged indoors at room temperature to ensure a full charge cycle
completes.